Re: Help Needed about the installation of RTLinux!

 
The biggest problem I had was *not* using bash as my default shell.  Tcsh (my 
shell of choice for the last 14 years) handles variables differently than 
bash, and did not properly propagate them to the various shell scripts... 
 
On that note, try setting your default shell to bash, make sure that any 
appropriate environment variables are set, and try rerunning. 
 
Also I assume that you have patched the kernel source with the patches 
provided with rtl-3.2_pre3? 
 
  EBo -- 
 
Ke Tang <[email protected]> said: 
 
> Hello everyone, 
>  
> I am trying to install RTLinux in my Dell Desktop following the 
> instructions I found in the internet, but I failed again and again. 
>  
> I can sucessful log in the new "real time linux", 
> but when I tried to use "make regression" to test my configuration, 
> the system had no response and hung. 
>  
> I guess I must do something wrong when configure the RTLinux/GPL 
> Kernel. I believe I chose the correct CPU type, checked "Code maturity 
> level options", check all "Loadable module support" and kernel hacking 
> and "Magic SysRq Key". 
>  
> Are there anything else I should pay special attention to?? 
> I am so frustrated about it..... 
> Anybody can help me? 
>  
> The Linux OS I am using is Red Hat Linux 9.0, and the linux kernel is 
> 2.4.20-8. The RTLinux is 3.2-pre3... 
>  
> Thanks. 
> _______________________________________________ 
> Rtl mailing list 
> [email protected] 
> http://www2.fsmlabs.com/mailman/listinfo/rtl 

_______________________________________________
Rtl mailing list
[email protected]
http://www2.fsmlabs.com/mailman/listinfo/rtl