Re: Problems installing RTLinux

Hi Shiv,

Im using redhat 9 and rtl3.2-pre3.  I used the instructions contained in :

 http://einstein.etsu.edu/jenkinss/rtlinux/rtlinux-testing/analysis/analysis-times-font.pdf.

and it worked perfectly. 

Regards,

Allan


On Tue, 15 Feb 2005 14:55:08 -0800 (PST), Shivdas Patil
<[email protected]> wrote:
> 
> 
>  Hello everyone,
>  I am using a RedHat 9.0 Linux Distribution running kernel version 2.4.20..
>  I am very much new to RTLinux & tried installing it ...
>  
>  Following were the steps I performed :-
>  
>  1) I downloaded the RTLinux patch rtlinux-3.2-pre2.tar & as the
> instructions were for kernel version 2.4.18, I downloaded a kernel 2.4.18..
>  
>  2) I applied the patch & compiled the new kernel successfully..
>  
>  3) Then I booted into my new kernel ( one with RTLinux) & configured the
> RTLinux..
>  
>  4) Now after restarting, when I try to "rtlinux start" at the command
> prompt , I get error when it tries to insert module ("insmod rtl-time.o") &
> the error is " You are trying to load a module without GPL Compatible
> License & it has unresolved symbols .Please contact your vendor"..
>  
>  & I can not do anything further...
>  I guess I have not set (or set) some configuration options in xconfig .....
>  
>  Any help, suggestions ,links would be of great help...
>  Thanks in Advance,
>  Shiv 
> 
>  
> _______________________________________________
> Rtl mailing list
> [email protected]
> http://www2.fsmlabs.com/mailman/listinfo/rtl
> 
> 
> 


-- 
Allan E Barredo
MiCOM Technologies
UP Ayala Techno Park
UP Diliman QC
_______________________________________________
Rtl mailing list
[email protected]
http://www2.fsmlabs.com/mailman/listinfo/rtl