Timer 0

For a data acquisition program, what would be the effects of reprogramming 
the timer 0 (change the countdown value) and the corresponding interrupt 
vector address to point to my hardware handler routine from within a RT 
thread?  I would do this for a few seconds and then return both to their 
prior settings.  This is what I used to do in a DOS program for very good 
interrupt timing.  I also disabled all other interrupts for those critical 
seconds, and read the CMOS clock and updated the system time of day clock 
when finished. Thanks.

Ed

_______________________________________________
Rtl mailing list
[email protected]
http://hq.fsmlabs.com/mailman/listinfo/rtl
http:/www.rtlinux-gpl.org/