Re: Fedora SMP dual core, dual AMD 64 processor system
"Bryan J. Smith" <[email protected]>
| Newsgroups | gmane.linux.redhat.amd64 |
|---|---|
| Message-ID | <[email protected]> |
Richard Emberson <[email protected]> wrote: > Bryan, your article was very interesting ... It's the 2nd (of currently 3) article in my "Dissecting" series. 2004 April was on ATA RAID Options. 2005 September (now) is on Virtual Tape Libraries (VTLs). > Can I assume that Figure 7 in the article is the Tyan > S2895? Actually Figure 7 is of a non-existant design. This is because mainboard vendors don't like to limit I/O if only one CPU is used. The CK04 Pro is the nVidia Pro 2200. There is also the nVidia Pro 2050. And then the AMD8131 (and 8132). My Figure 7 only used the first (CPU#0) and last (CPU #1). The Tyan S2895 uses all 3. On the Tyan S2895, the 2200 and 8131 are attached to CPU#0. The 2050 is attached to CPU#1. As far as 4-way designs go, Figure 5 is the HP DL585. There are two (2) AMD8131 ICs, one attached to half of the Opterons. Some on-board peripherals might be attached to some. The Sun SunFire V40z is actually a bit better (based on another company's design) in the I/O department (the management IC is another story compared to the HP ;-). It uses three (3) AMD8131 ICs, two attached to one Opteron, and one attached to another Opteron. In the case of the two attached to one Opteron -- the resulting four (4) PCI-X channels are single 133MHz PCI-X channels. That's 4 slots of dedicated 1GBps channels of PCI-X I/O on one CPU. The other PCI-X channels are used for on-board peripherals and slower 66MHz slots. -- Bryan J. Smith | Sent from Yahoo Mail mailto:[email protected] | (please excuse any http://thebs413.blogspot.com/ | missing headers) -- amd64-list mailing list [email protected] https://www.redhat.com/mailman/listinfo/amd64-list