Re: Notifying post-install tools about screens seen by the user

On Fri, 2015-11-06 at 09:25 -0800, Brian C. Lane wrote:
> On Fri, Nov 06, 2015 at 01:17:11PM +0100, Vojtěch Trefný wrote:
> > 
> > 
> > On 5.11.2015 18:11, Brian C. Lane wrote:
> > > On Thu, Nov 05, 2015 at 04:59:07PM +0100, Martin Kolman wrote:
> > > 
> > > Visiting a spoke isn't the same as changing something. I think we
> > > should
> > > base this on changes, shouldn't we?
> > > 
> > 
> > But if you visit a spoke without changing something, it means the
> > defaults
> > are ok for you and you're probably not going to change them later.
> > 
> > Maybe we could put both "visited" and "changed" to the file and let
> > Initial
> > Setup (and other) decide.
> 
> The problem is we have no way to know what they intended if they
> haven't
> changed anything. Maybe they were just exploring?

And what about some timeout? They must be in a spoke I don't know maybe
5 seconds only then you set it as visited. I think when the user will
be 5 or more seconds he saw the settings and confirmed it even when
she/he doesn't changed it.

_______________________________________________
Anaconda-devel-list mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/anaconda-devel-list