Re: UP2000+ Problems

Jeff,

I was able to run a UP2000+ 2x667 and full load of RAM off an Enermax 450W
power supply, the quiet model.  That was with a single SCSI hard drive and a
CDROM.  It was barely enough rated power but that particular PSU must have a
little reserve capacity.

If you have a comparable PSU you might try using it to test your board.  Just
a thought.

jn


---------- Original Message -----------
From: jmd <[email protected]>
To: Linux on Alpha processors <[email protected]>
Sent: Fri, 19 Feb 2010 13:08:06 -0800
Subject: Re: UP2000+ Problems

> On Fri, 2010-02-19 at 15:41 -0500, Matt Turner wrote:
> 
> > 
> > If the problem persists with a working power supply, then we might
> > consider that the CPUs or motherboard are somehow faulty. The CPUs
> > were run with a higher (read: wrong) voltage for a non-trivial amount
> > of time after all.
> > 
> > Matt Turner
> 
> i should have stated i am not interested in investing any money in this
> board. good power supplies are not cheap.
> 
> thanks
> jeff duncan
> 
> _______________________________________________
> axp-list mailing list
> [email protected]
> https://www.redhat.com/mailman/listinfo/axp-list
> 
> -- 
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
------- End of Original Message -------