Re: Can I add speakup to An Existing Wheezy Installation?
John G Heim <[email protected]>
| Newsgroups | gmane.linux.redhat.blinux.general |
|---|---|
| Message-ID | <[email protected]> |
If you are using a stock debian kernel, you don't have to add speakup. You just have to load it. I am guessing though that you are asking how to load speakup, right? Well, that depends on which speech synth you are using. I am going to guess you want to use software speech, right? In that case, you will have to add the espeak package. Here are the steps: 1. Type "modprobe speakup_soft" 2. Type "apt-get install espeakup" Your machine should start talking. technically not speakup. On 12/04/2016 01:16 PM, Martin McCormick wrote: > The subject is really the whole message. The wheezy > installation is on a system with 384 MB of ram so there is no > orca but I have seen speakup run on less although this is > scraping the bottom of the barrel. > > Any good ideas are welcome. Thank you. > > Martin McCormick WB5AGZ > > _______________________________________________ > Blinux-list mailing list > [email protected] > https://www.redhat.com/mailman/listinfo/blinux-list >