RE: FireWire HDD problem
"Rishabh Kumar Goel" <[email protected]> Tue, 19 Aug 2003 10:06:04 +0530
| Newsgroups | gmane.linux.redhat.devel |
|---|---|
| Message-ID | <[email protected]> |
Hi there, Well I checked out the driver but there is no jumper setting available on the disk, like the case in IDE. It just have :- 1. Power Connector 2. 2 FireWire Ports Apart from this there is nothing outside the drive. Regards, Rishabh -----Original Message----- From: Dan Hollis [mailto:[email protected]] Sent: Monday, August 18, 2003 11:27 PM To: Rishabh Kumar Goel Cc: [email protected] Subject: Re: FireWire HDD problem On Mon, 18 Aug 2003, Rishabh Kumar Goel wrote: > I have a Bencent 3.5" FireWire HDD. I also have a TI's TSB43ab22 iOHCI PCI > card with a PCI-PCI bridge interface. You have to set the drive for cable select, not master or slave. -Dan -- [-] Omae no subete no kichi wa ore no mono da. [-] Scanned by SecureSynergy VirusScreen Service. For more information log on to : http://www.securesynergyonline.com or http://www.securesynergy.com