Canon S300 USB printer os FC 3 not working.

I'm working on a box with a Cannon S300 USB printer 
attached.  When I booted up after installing Kudzu detected 
the printer and seemed to configure it without any trouble.

When I went to print something, nothing.  No error 
message-no printing.  When I examined the configuration it 
said that it is hooked up to /dev/usb/lp0.  That doesn't exist.

I suspect udev.  I unpluged the printer from the computer 
and listed the contents of /dev.  I plugged it back in and 
listed the contents again.  No difference.

Has anyone successfully used this printer on Fedora 3?  If 
so how?


-- 
Mark Healey
[email protected]

-- 
Fedora-config-list mailing list
[email protected]
http://www.redhat.com/mailman/listinfo/fedora-config-list