RE: Re:ip address

The issue is most likely that interface is not configured to auto start

Look at /etc/sysconfig/network-scripts/ifcfg-eth0

Change onboot to yes

Josh Moore
RHCE

-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of [email protected]
Sent: Thursday, May 08, 2014 3:06 PM
To: [email protected]; [email protected]
Subject: Re:ip address

Hello Members, 

I have new rhel 6.5 environment. The issue that I am facing could be a ridiculous, but it is. when I first did ifconfig I could just see loopback IP address, however, I executed "ifup eth0", and now I could see the IPv4. However, if I again to "service network restart" The Ip address goes away, and again loop back. Am I missing something?

Regards,

Amitesh 
-- 
redhat-list mailing list
unsubscribe mailto:[email protected]?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list

-- 
redhat-list mailing list
unsubscribe mailto:[email protected]?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list