Re: Kickstart install over gige interface on HP zx6000

Yes, that could be it.  But why?  I suppose I could try forcing the card
to 1000FD, but again, it works for static address, without forcing the
card to any duplex settings.  And the static address is assigned by the
DHCP server, making it even more bizarro....

Jason P Holland
Texas Learning and Computation Center
http://www.tlc2.uh.edu
University of Houston
Philip G Hoffman Hall rm 207A
tel: 713-743-4850
cell: 281-451-5991

On Mon, 14 Jul 2003, Bill Nottingham wrote:

> Jason Holland ([email protected]) said:
> >   I'm hoping someone can help with this peculiar problem.  I am trying to
> > setup an automated kickstart install on an HP zx6000.  The machine has
> > dual interfaces, 1 10/100 and also a gige interface.  Our cluster
> > currently takes advantage of the gige interface, so consequently I'd like
> > to do my automated installs over that interface.  However, the RedHat
> > installer will not assign a dhcp address during the install, it just
> > hangs.  It gets weird.  This works perfectly fine if I use a static
> > address, so the interface is good and functions.  DHCP assignment will
> > work if I use the 10/100 interface, so DHCP is setup correctly.  When I do
> > a lanboot from the EFI shell and select the gige interface, I get an IP
> > address, and the tftpboot sequence kicks off ok.  But somehow if fails to
> > get an ip during the install.  Has anyway had this problem before?
>
> Perhaps it's not negotiating correctly?
>
> Bill
>
>
> _______________________________________________
> ia64-list mailing list
> [email protected]
> https://www.redhat.com/mailman/listinfo/ia64-list
>