Re: Kickstart install over gige interface on HP zx6000

I have discovered something else.  When I use the 10/100 interface, from
the efi shell I initiate a lanboot and I see the DHCP requests in the logs
on the dhcp server.  However, when it starts the install, I don't see
another DHCP request, even though I specified that for the install and its
getting a dynamic address and somehow using it.  Why in the world is that?
Is it somehow passing the initial ip address into the install?  How would
it know where to get it from??

Jason P Holland
Texas Learning and Computation Center
http://www.tlc2.uh.edu
University of Houston
Philip G Hoffman Hall rm 207A
tel: 713-743-4850
cell: 281-451-5991

On Mon, 14 Jul 2003, Brent M. Clements wrote:

> Jason,
>  If your not getting a dhcp request from the machine then you have another
> problem. Either configuration or hardware on the client. Check the cable.
>
> Can you send your kickstart file to me?
>
> -Brent
>
> Brent Clements
> HPC Technology Specialist
> Information Technology
> Rice University
>
>
>