Can't boot 7.2 ia64 after installation

I was looking through the archives to solve my problem and I came upon this
thread.  I also can't boot after the install.  I did boot form the ls-120
disk in rescue mode, then mounted / and looked at /tmp/install.log  There
are no failures in this file.  I wanted to check the status of my boot
partition, but I'm not sure how or where to do this.  I assume that to are
referencing a boot partition via the efi shell?


Dmitri Trembovetski ([email protected]) said: 
>   fs0:\
>    efi\
>    elilo.conf
>    elilo.efi
> 
>   fs0:\efi\boot\
>     bootia64.efi

Hm, that's not good - no kernel. My first suggestion would be to 
boot the installer in rescue mode, mount your root partition and
look in /tmp for the install.log, and see if there are errors from
installing the kernel RPMs.

Bill



--
Mike Cannon
Infrastructure/SANs System Administrator
IT Computing Services
Purdue University
1061 Freehafer Hall (FREH)
401 S. Grant Street
West Lafayette, IN  47907-1061

office phone: 765.494.6357
office fax: 765.496.1380
email: [email protected]