Re: ltspbr0 & ethx packet descripincy

Could it be that txqueuelen setting on eth0?  There's a difference 
there.  I tried googling this, but haven't found out exactly what that 
is or does though.  I could see forcing a certain queue size adding 
packets to what eventually gets sent, if there is also some minimum time 
interval to flushing the queue or something.  But I'm certainly not 
smarter than you.

ck

snip
> On 12/28/2012 9:00 AM, [email protected] wrote:
> eth0      Link encap:Ethernet  HWaddr 00:00:00:00:59:11
>            inet6 addr: 0000::000:4cff:fe20:5911/64 Scope:Link
>            UP BROADCAST RUNNING PROMISC MULTICAST  MTU:1500  Metric:1
>            RX packets:79411529 errors:0 dropped:0 overruns:0 frame:0
>            TX packets:109054017 errors:0 dropped:0 overruns:0 carrier:0
>            collisions:0 txqueuelen:1000
>            RX bytes:775690448 (739.7 MiB)  TX bytes:1766710101 (1.6 GiB)
>            Interrupt:26 Base address:0xe000
>
/snip
> Thanks,
> Barry
>

_______________________________________________
K12OSN mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/k12osn
For more info see <http://www.k12os.org>