Re: beta fc 15 strange read error on USB stick drive

Steve Robson <[email protected]>
Newsgroups gmane.linux.redhat.kickstart.general
Organization Cadence Design Systems
Message-ID <[email protected]>
[email protected] wrote:
>
> I downloaded the Beta on May 1. It uses anaconda 15.27 (11:555:41). I
> boot off
> a sandisk FAT32 32GB USB stick (which has a single partition) and with my
> kickstart file is on that drive.
> Intermittantly (about 50% of the time over the last 6 times I have tried)
> immediately after the probing the ethernet Network device screen (device
> is from
> my kickstart file) (and hence AFTER my kickstart file has been read in)
> I get
> a screen that says:
> My sandisk drive may contain data... We could not detect partitions...
> And it presents a box which says:
> Apply my choice to all such devices
> (Which I check)
> And below that two choices:
> Yes, discard data...
> No, keep data...
> Which I select.
> The Examining Storage Devices screen then appears and the install always
> proceeds and finishes OK after that.
> Is there any way I can specify these two selections in my kickstart file.
> I don't ZERO my MSB and I don't clear the partions (just use a single onpart
> to format an existing ext3 partition) so it seems that it should be able to
> figure that I don't want any other data destroyed (and not the one my
> kickstart file is on).
> Any help will be greatly appreciated.
> Floyd,

Not sure if it's FC-compatible but the "ignoredisk" kickstart directive 
might be suitable.  Something like:

   ignoredisk --drives=drive1,drive2,...
   where driveN is one of sda, sdb,..., hda,... etc.

or:
   ignoredisk --only-use=sda
   which specifies a list of disks for the installer to use. All other
   disks are ignored. For example, to use disk sda during installation
   and ignore all other disks.

Lifted from 
http://docs.redhat.com/docs/en-US/Red_Hat_Enterprise_Linux/6/html/Installation_Guide/s1-kickstart2-options.html 


-- 
   Regards,
   Steve

IT Support - UNIX/Linux                        Cadence Design Systems
                                                Bagshot Road
                                                Bracknell BERKSHIRE
                                                RG12 0PH   UK
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.