Re: Driver disk loading via NFS fails on Cisco switch, OK on Dell

whitivery <[email protected]>
Newsgroups gmane.linux.redhat.kickstart.general
Message-ID <[email protected]>
david klein <[email protected]> wrote:

>Check to see if the client, switch and up-stream router agree on maximum
>frame-size (i.e. if one is trying to do jumbo-frames and the other can't,
>it can cause troubles). Make sure the switch-port that the client is using
>is setup as an access-port, not a trunk. Set the client's port for
>spanning-tree portfast and turn on BPDU-guard.

Thank you for the response.  Had already tried spanning-tree portfast
before turning off spanning-tree entirely, no difference.  I will look
into the other things you mention.

Updated observations:

- Problem happens exactly the same with a switch at the opposite
  end of the complexity spectrum - Netgear 5 port 10/100Mbps
  Switch FS605 v3.

- I noticed that on the good switch, you see two eth0 dialogs
  flash up before it proceeds; on a bad switch, only see one eth0
  dialog then the empty blue screen.

- If while it's in the failure state with the empty blue screen,
  I move the target's network connection to the good switch, it
  immediately takes off and continues the kickstart process
  properly.



>On Sun, Nov 13, 2011 at 1:53 PM, whitivery <[email protected]>wrote:
>
>> I have a working Cobbler server, using it to load units with
>> CentOS 5.7.  It works fine with a simple Dell 2716 switch
>> connecting the server and targets.  Also with a LinkSys RV016.
>>
>> Substituting a Cisco 2960 switch, it fails.  It network boots,
>> shows the PXE menu, I choose an entry, it gets a DHCP address on
>> its eth0, and starts loading including getting its kickstart via
>> HTTP.  But when it goes to load the driver disk image via NFS, it
>> hangs.  The Anaconda Alt-F4 screen shows it not seeing the NFS
>> server; after 2 minutes of trying, it times out and the Alt-F4
>> screen shows an error dump.
>>
>> Tried the switch with and without RST (rapid spanning tree)
>> active, no difference.
>>
>> The switch seems to work OK for normal network operations outside
>> the kickstart environment, for what we use.
>>
>> Any idea what it might be that could be interfering with the NFS
>> disk driver loading step?
>>
>>
>> _______________________________________________
>> Kickstart-list mailing list
>> [email protected]
>> https://www.redhat.com/mailman/listinfo/kickstart-list
>>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.