kickstart dhcp issues
Sir June <[email protected]>
| Newsgroups | gmane.linux.redhat.kickstart.general |
|---|---|
| Message-ID | <[email protected]> |
Hi, I am using a Poweredge R710 with 4 embedded NICs. I have a kickstart procedure using http. So i boot from my USB, type in: linux ks=http://x.x.x.x./path/ks.cfg Anaconda prompts me then which eth to use, i selected eth0 (which is connected to the network). But the sending request for IP information is taking forever. I them timesout, asks to select ipv4/ipv6 options. And back to "sending request for ip info...." I am also using a cisco switch on the other end and changes in the switch config is not an option.This issue defeats auto install of Redhat. IF i connect the server into a normal switch (not Cisco), kickstart works fine., How to set something that anaconda will continue to request & wait for DHCP ip. thanks, sirjun _______________________________________________ Kickstart-list mailing list [email protected] https://www.redhat.com/mailman/listinfo/kickstart-list