Re: kickstart dhcp issues
Sir June <[email protected]>
| Newsgroups | gmane.linux.redhat.kickstart.general |
|---|---|
| Message-ID | <[email protected]> |
I thank you all for the comments, solutions and suggestions. as of yesterday, I was able to install RHEL5.5 via kickstart using linux ks=http://192.168xxx.xxx/redhat/ks.cfg dhcptimeout=500 although it still asks me as to which ethernet to use, (eth0..eth5). it continues afterwards. I tried specifying ksdevice=eth0 and noipv6 but the installation wont proceed and keeps on coming back to the ipv4 and ipv6 selections. I will try all the suggestions & options mentioned here. thanks, Sirjune ________________________________ From: Angus Clarke <[email protected]> To: Discussion list about Kickstart <[email protected]> Sent: Monday, January 30, 2012 3:13 PM Subject: Re: kickstart dhcp issues Perhaps - I didn't read the Dell solution as specifying MAC addresses is sufficient and already available, at least for my requirements (Ethernet interfaces) All the best ~Angus On 30 January 2012 20:06, Kaj Niemi <[email protected]> wrote: I think this is what the dell naming scheme was designed to prevent… :-) > > > > > > > > >Kaj > >On Jan 30, 2012, at 18:36, Angus Clarke wrote: > >I notice that without specifying the device MAC address in the config files you are concerned with, and then later adding additional NICs on the PCIe bus - results in the PCIe NICs preceding the onboard NICs (eth0 changes to represent the NIC on the lowest PCIe bus.) >> >>HP DL380 G7 and RHEL5.2 x86_64 > >_______________________________________________ >Kickstart-list mailing list >[email protected] >https://www.redhat.com/mailman/listinfo/kickstart-list > _______________________________________________ Kickstart-list mailing list [email protected] https://www.redhat.com/mailman/listinfo/kickstart-list _______________________________________________ Kickstart-list mailing list [email protected] https://www.redhat.com/mailman/listinfo/kickstart-list