Re: How to configure a libvirt network in %post (virsh fails due to libvirtd unable to run)

Patrick Lists <[email protected]>
Newsgroups gmane.linux.redhat.kickstart.general
Message-ID <[email protected]> 
On 03/29/2012 09:13 PM, Hugh Brown wrote:
> On my F16, I wasn't able to start cups via systemctl or via the service
> command. I had to start it via /usr/sbin/cupsd.
>
> I expect that you'll need to start libvirtd by hand rather than by using
> /sbin/service.
>
> You'll also likely need to stop it once you are done calling virsh.

Thanks I'll give that a try.

Regards,
Patrick
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.