Re: Kickstart hangs at dracut-initqueue (CentOS 7.2)
Frantisek Krecmer <[email protected]> Thu, 14 Apr 2016 21:46:03 +0200
| Newsgroups | gmane.linux.redhat.kickstart.general |
|---|---|
| Message-ID | <CAG64i+Mct7_4QiyR2cfizPEea7W8FQJ-1xtS=h0kGrvFBWw+Lw@mail.gmail.com> |
--===============3444875834932998431== Content-Type: multipart/alternative; boundary=001a1143fa4c0034bc05307725c1 --001a1143fa4c0034bc05307725c1 Content-Type: text/plain; charset=UTF-8 Hello, I had similar problem with RHEL7 recently and it was caused by network. I configured wrong NIC during installation and it dropped to dracut shell. Regards, FK On Thu, Apr 14, 2016 at 9:20 PM, therbur <[email protected]> wrote: > therbur <[email protected]> wrote: > > >I have a Cobbler setup that loads a CentOS 5.7 OK. I am trying to add a > >CentOS 7.2 load. > > > >It stops just after the line that shows: > > > >... dracut-initqueue ... Dload Upload Total Spent Left Speed > > > >Actually, it doesn't stop, it just pauses a long time, then says dozens of > >messages like: > > > >... warning: dracut-initqueue timeout - starting timeout scripts > > > >Then it comes to a "dracut>" prompt. Doing "journalctl" as it suggests, I > >don't see anything obvious that would tell me the actual problem. Also > >tried "cat /proc/cmdline" and it worked, didn't see anything unusual. > > > >What is it looking for when it gets to the dracut-initqueue line? What > >are some possible causes/solutions? > > No ideas? In case it's helpful, here's the dracut rdsosreport.txt for the > problem: > > http://pastebin.com/uyx8p9bA > > > _______________________________________________ > Kickstart-list mailing list > [email protected] > https://www.redhat.com/mailman/listinfo/kickstart-list > --001a1143fa4c0034bc05307725c1 Content-Type: text/html; charset=UTF-8 Content-Transfer-Encoding: quoted-printable <div dir=3D"ltr">Hello,<div><br></div><div>I had similar problem with RHEL7= recently and it was caused by network. I configured wrong NIC during insta= llation and it dropped to dracut shell.=C2=A0</div><div><br></div><div>Rega= rds,</div><div>FK</div></div><div class=3D"gmail_extra"><br><div class=3D"g= mail_quote">On Thu, Apr 14, 2016 at 9:20 PM, therbur <span dir=3D"ltr"><= <a href=3D"mailto:[email protected]" target=3D"_blank">fxb7-ox9n@de= a.spamcon.org</a>></span> wrote:<br><blockquote class=3D"gmail_quote" st= yle=3D"margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><span= class=3D"">therbur <<a href=3D"mailto:[email protected]">fxb7-o= [email protected]</a>> wrote:<br> <br> >I have a Cobbler setup that loads a CentOS 5.7 OK.=C2=A0 I am trying to= add a<br> >CentOS 7.2 load.<br> ><br> >It stops just after the line that shows:<br> ><br> >... dracut-initqueue ...=C2=A0 Dload Upload Total Spent Left Speed<br> ><br> >Actually, it doesn't stop, it just pauses a long time, then says do= zens of<br> >messages like:<br> ><br> >... warning: dracut-initqueue timeout - starting timeout scripts<br> ><br> >Then it comes to a "dracut>" prompt.=C2=A0 Doing "jou= rnalctl" as it suggests, I<br> >don't see anything obvious that would tell me the actual problem.= =C2=A0 Also<br> >tried "cat /proc/cmdline" and it worked, didn't see anyth= ing unusual.<br> ><br> >What is it looking for when it gets to the dracut-initqueue line?=C2=A0= What<br> >are some possible causes/solutions?<br> <br> </span>No ideas?=C2=A0 In case it's helpful, here's the dracut rdso= sreport.txt for the<br> problem:<br> <br> <a href=3D"http://pastebin.com/uyx8p9bA" rel=3D"noreferrer" target=3D"_blan= k">http://pastebin.com/uyx8p9bA</a><br> <div class=3D"HOEnZb"><div class=3D"h5"><br> <br> _______________________________________________<br> Kickstart-list mailing list<br> <a href=3D"mailto:[email protected]">[email protected]</a><= br> <a href=3D"https://www.redhat.com/mailman/listinfo/kickstart-list" rel=3D"n= oreferrer" target=3D"_blank">https://www.redhat.com/mailman/listinfo/kickst= art-list</a><br> </div></div></blockquote></div><br></div> --001a1143fa4c0034bc05307725c1-- --===============3444875834932998431== Content-Type: text/plain; charset="us-ascii" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit Content-Disposition: inline _______________________________________________ Kickstart-list mailing list [email protected] https://www.redhat.com/mailman/listinfo/kickstart-list --===============3444875834932998431==--