Re: Kickstart hangs at dracut-initqueue (CentOS 7.2)
Masahiro Matsuya <[email protected]> Fri, 15 Apr 2016 17:18:48 +0900
| Newsgroups | gmane.linux.redhat.kickstart.general |
|---|---|
| Message-ID | <CADjNeK3J_aw5Cr-iTsD+8Ojvsx=Qfy9GQEzLgZXC217JEFkqHg@mail.gmail.com> |
--===============4419846991253268308== Content-Type: multipart/alternative; boundary=001a113ced740b0560053081a961 --001a113ced740b0560053081a961 Content-Type: text/plain; charset=UTF-8 Or, sosreport.txt collected with rd.debug boot option will provide a valuable information to know the root cause. On Fri, Apr 15, 2016 at 4:14 PM, Oliver Haessler <[email protected]> wrote: > Is there a way to have a look at the kickstart file? It might be easier > than guessing :D > > ----- Original Message ----- > > From: "therbur" <[email protected]> > > To: [email protected] > > Sent: Friday, April 15, 2016 8:43:40 AM > > Subject: Re: Kickstart hangs at dracut-initqueue (CentOS 7.2) > > > > Frantisek Krecmer <[email protected]> wrote: > > > > >Hello, > > > > > >I had similar problem with RHEL7 recently and it was caused by > > >network. I > > >configured wrong NIC during installation and it dropped to dracut > > >shell. > > > > > >Regards, > > >FK > > > > Thanks for the response. > > > > I don't think it's the NIC - I don't specify anything; there's only > > one > > Ethernet port connected, and with CentOS 5.7 it works fine, I think > > kickstart defaults to whatever link it is using to PXE boot, which is > > what > > is needed; I don't know why this aspect would be any different > > between the > > distros. At one point I did try the second of the two Ethernet ports > > on > > the unit being loaded, and it did not get any further. > > > > > > > >On Thu, Apr 14, 2016 at 9:20 PM, therbur <[email protected]> > > >wrote: > > > > > >> therbur <[email protected]> wrote: > > >> > > >> >I have a Cobbler setup that loads a CentOS 5.7 OK. I am trying > > >> >to add a > > >> >CentOS 7.2 load. > > >> > > > >> >It stops just after the line that shows: > > >> > > > >> >... dracut-initqueue ... Dload Upload Total Spent Left Speed > > >> > > > >> >Actually, it doesn't stop, it just pauses a long time, then says > > >> >dozens of > > >> >messages like: > > >> > > > >> >... warning: dracut-initqueue timeout - starting timeout scripts > > >> > > > >> >Then it comes to a "dracut>" prompt. Doing "journalctl" as it > > >> >suggests, I > > >> >don't see anything obvious that would tell me the actual problem. > > >> > Also > > >> >tried "cat /proc/cmdline" and it worked, didn't see anything > > >> >unusual. > > >> > > > >> >What is it looking for when it gets to the dracut-initqueue line? > > >> > What > > >> >are some possible causes/solutions? > > >> > > >> No ideas? In case it's helpful, here's the dracut rdsosreport.txt > > >> for the > > >> problem: > > >> > > >> http://pastebin.com/uyx8p9bA > > >> > > >> > > >> _______________________________________________ > > >> Kickstart-list mailing list > > >> [email protected] > > >> https://www.redhat.com/mailman/listinfo/kickstart-list > > >> > > > > > > _______________________________________________ > > Kickstart-list mailing list > > [email protected] > > https://www.redhat.com/mailman/listinfo/kickstart-list > > > > _______________________________________________ > Kickstart-list mailing list > [email protected] > https://www.redhat.com/mailman/listinfo/kickstart-list > --001a113ced740b0560053081a961 Content-Type: text/html; charset=UTF-8 Content-Transfer-Encoding: quoted-printable <div dir=3D"ltr">Or, sosreport.txt collected with rd.debug boot option will= provide a valuable information to know the root cause.<br></div><div class= =3D"gmail_extra"><br><div class=3D"gmail_quote">On Fri, Apr 15, 2016 at 4:1= 4 PM, Oliver Haessler <span dir=3D"ltr"><<a href=3D"mailto:oliver@redhat= .com" target=3D"_blank">[email protected]</a>></span> wrote:<br><blockqu= ote class=3D"gmail_quote" style=3D"margin:0 0 0 .8ex;border-left:1px #ccc s= olid;padding-left:1ex">Is there a way to have a look at the kickstart file?= It might be easier than guessing :D<br> <div class=3D"HOEnZb"><div class=3D"h5"><br> ----- Original Message -----<br> > From: "therbur" <<a href=3D"mailto:[email protected].= org">[email protected]</a>><br> > To: <a href=3D"mailto:[email protected]">Kickstart-list@redhat= .com</a><br> > Sent: Friday, April 15, 2016 8:43:40 AM<br> > Subject: Re: Kickstart hangs at dracut-initqueue (CentOS 7.2)<br> ><br> > Frantisek Krecmer <<a href=3D"mailto:[email protected]">f.krecmer= @gmail.com</a>> wrote:<br> ><br> > >Hello,<br> > ><br> > >I had similar problem with RHEL7 recently and it was caused by<br> > >network. I<br> > >configured wrong NIC during installation and it dropped to dracut<= br> > >shell.<br> > ><br> > >Regards,<br> > >FK<br> ><br> > Thanks for the response.<br> ><br> > I don't think it's the NIC - I don't specify anything; the= re's only<br> > one<br> > Ethernet port connected, and with CentOS 5.7 it works fine, I think<br= > > kickstart defaults to whatever link it is using to PXE boot, which is<= br> > what<br> > is needed; I don't know why this aspect would be any different<br> > between the<br> > distros.=C2=A0 At one point I did try the second of the two Ethernet p= orts<br> > on<br> > the unit being loaded, and it did not get any further.<br> ><br> > ><br> > >On Thu, Apr 14, 2016 at 9:20 PM, therbur <<a href=3D"mailto:fxb= [email protected]">[email protected]</a>><br> > >wrote:<br> > ><br> > >> therbur <<a href=3D"mailto:[email protected]">fxb7= [email protected]</a>> wrote:<br> > >><br> > >> >I have a Cobbler setup that loads a CentOS 5.7 OK.=C2=A0 = I am trying<br> > >> >to add a<br> > >> >CentOS 7.2 load.<br> > >> ><br> > >> >It stops just after the line that shows:<br> > >> ><br> > >> >... dracut-initqueue ...=C2=A0 Dload Upload Total Spent L= eft Speed<br> > >> ><br> > >> >Actually, it doesn't stop, it just pauses a long time= , then says<br> > >> >dozens of<br> > >> >messages like:<br> > >> ><br> > >> >... warning: dracut-initqueue timeout - starting timeout = scripts<br> > >> ><br> > >> >Then it comes to a "dracut>" prompt.=C2=A0 D= oing "journalctl" as it<br> > >> >suggests, I<br> > >> >don't see anything obvious that would tell me the act= ual problem.<br> > >> > Also<br> > >> >tried "cat /proc/cmdline" and it worked, didn&#= 39;t see anything<br> > >> >unusual.<br> > >> ><br> > >> >What is it looking for when it gets to the dracut-initque= ue line?<br> > >> > What<br> > >> >are some possible causes/solutions?<br> > >><br> > >> No ideas?=C2=A0 In case it's helpful, here's the drac= ut rdsosreport.txt<br> > >> for the<br> > >> problem:<br> > >><br> > >> <a href=3D"http://pastebin.com/uyx8p9bA" rel=3D"noreferrer" t= arget=3D"_blank">http://pastebin.com/uyx8p9bA</a><br> > >><br> > >><br> > >> _______________________________________________<br> > >> Kickstart-list mailing list<br> > >> <a href=3D"mailto:[email protected]">Kickstart-list@r= edhat.com</a><br> > >> <a href=3D"https://www.redhat.com/mailman/listinfo/kickstart-= list" rel=3D"noreferrer" target=3D"_blank">https://www.redhat.com/mailman/l= istinfo/kickstart-list</a><br> > >><br> ><br> ><br> > _______________________________________________<br> > Kickstart-list mailing list<br> > <a href=3D"mailto:[email protected]">[email protected]= </a><br> > <a href=3D"https://www.redhat.com/mailman/listinfo/kickstart-list" rel= =3D"noreferrer" target=3D"_blank">https://www.redhat.com/mailman/listinfo/k= ickstart-list</a><br> ><br> <br> _______________________________________________<br> Kickstart-list mailing list<br> <a href=3D"mailto:[email protected]">[email protected]</a><= br> <a href=3D"https://www.redhat.com/mailman/listinfo/kickstart-list" rel=3D"n= oreferrer" target=3D"_blank">https://www.redhat.com/mailman/listinfo/kickst= art-list</a><br> </div></div></blockquote></div><br></div> --001a113ced740b0560053081a961-- --===============4419846991253268308== Content-Type: text/plain; charset="us-ascii" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit Content-Disposition: inline _______________________________________________ Kickstart-list mailing list [email protected] https://www.redhat.com/mailman/listinfo/kickstart-list --===============4419846991253268308==--