Re: Network funkyness

Dan,

Both directors.  You may want to look at piranha-gui.  Piranha also will
handle the stopping of daemons on one and transition to the other.

Regards,
BMan


pb wrote:
> 
> --- Daniel Burke <[email protected]> wrote:
> > 1.  Shutdown heartbeat on the load balancer so it
> > failed over to the secondary.
> > 2.  Make the kernel change and recompile/reboot.
> > 3.  Bring heartbeat back up on the primary.
> 
> Hello. When I went to add a 2nd Piranha/LVS and enable
> a heartbeat, I realized my concept of the hearbeat as
> applies to two LVS boxes was lacking.  Do I setup the
> acting LVS so its heartbeat setting is the IP address
> of the fail-over LVS, or do I tell the fail-over LVS
> the heartbeat is the IP address of the acting LVS, so
> that if the fail-over LVS ceasing to locate the acting
> LVS, then it picks up the Public IP address ???
> AND at such a point, how do I kick off a script which
> does an ifup eth0:1  and bring up LVS daemons ???
> 
> Note Piranha is the same as regular LVS but does have
> an lvs.cf file too which contains all the setups.
> 
> Your direction on this would be most appreciated.
> 
> Thanks
> Peter
> 
> __________________________________________________
> Do You Yahoo!?
> Yahoo! - Official partner of 2002 FIFA World Cup
> http://fifaworldcup.yahoo.com
> 
> _______________________________________________
> Piranha-list mailing list
> [email protected]
> https://listman.redhat.com/mailman/listinfo/piranha-list

-- 
Regards, 
BMan  (Brian Gray)

"Things should be made as simple as possible, but not any simpler." 
A.E.