Re: Testing lvs using Piranha 0.7.0-3 in Linux 8.0

I can start Pulse now by setting backup_active=0.

 --- ong cheechye <[email protected]> wrote: >
Thanks Peter. Can I use Linux 7.3 to generate the
> lvs.cf and run piranha on Linux 8.0 ?
> 
> I just tried to edit lvs.cf from the shell in Linux
> 8.0 to try out if piranha can perform the minimal
> lvs
> function only (i.e without backup director and only
> 1
> realserver). I got the following message when
> starting
> pulse:
> 
> [root@main ha]# /etc/rc.d/init.d/pulse start
> Starting pulse:                                     
>  
>     [FAILED]
> 
> I have tested lvs direct routing and telenet service
> with the same vip and rip using the rc.lvs_dr script
> and it seemed ok (i.e I get 1 active conn from
> ipvsadm
> when telnet to vip from a client). My network setup
> is
> 1 director, 1 realserver and client are all on the
> same network
> 
> Is there anything wrong with my 'very minimal'
> piranha
> configuration as the error message does not indicate
> specific reason of failure. Would appreciate any
> help
> and suggestion in testing lvs through piranha in
> Linux
> 8.0.
> 
> Below is my lvs.cf file (most of the options have
> been
> commented).
> 
> [root@main ha]# cat lvs.cf
> service = lvs
> primary = 192.168.123.109
> # primary_private = 192.168.123.109
> # primary_shared = /dev/sdb
> # backup = 207.175.44.196
> backup_active = 1
> # backup_private = 10.11.12.2
> # backup_shared = /dev/sdb
> # backup_active = 1
> # heartbeat = 1
> # heartbeat_port = 1050
> # keepalive = 6
> # deadtime = 18
> # reservation_conflict_action = preempt
> # debug_level = NONE
> # rsh_command = rsh
> network = direct
> # nat_router = 192.168.10.100 eth1:1
> # nat_nmask = 255.255.255.255
> 
> virtual server1 {
>         address = 192.168.123.110 eth0:1
>         vip_nmask = 255.255.255.255
> #       fwmark = 100
>         active = 1
> #       load_monitor = uptime
> #       timeout = 5
> #       reentry = 10
>         port = 23
> #       send = "GET / HTTP/1.0\r\n\r\n"
> #       expect = "HTTP"
>         scheduler = rr
>         persistent = 60
>         pmask = 255.255.255.255
>         protocol = tcp
> 
>         server Real1 {
>                 address = 192.168.123.198
>                 active = 1
>                 weight = 1
>         }
> }
> 
> 
> __________________________________________________
> Do You Yahoo!?
> Promote your business from just $5 a month!
> http://sg.biztools.yahoo.com
> 
> 
> 
> _______________________________________________
> Piranha-list mailing list
> [email protected]
>
https://listman.redhat.com/mailman/listinfo/piranha-list 

__________________________________________________
Do You Yahoo!?
Promote your business from just $5 a month!
http://sg.biztools.yahoo.com