Re: Firewall marks not working as expected?

> Am I doing something completely wrong here?  Anyone
> have any suggestions?

When using firewall marks, you define your virtual service just once. 
That's the benefit ! Imagine you have 20 ports bundled using the same 
fwmark, you'll have only one virtual service.

For the record, in your second (and useless) virtual server, you defined 
port 443 (SSL) but try to send a plain HTTP request. This CAN'T work !

Your lvs.cf should be :

service = lvs
primary = 10.0.0.1
backup = 10.0.0.2
backup_active = 1
heartbeat = 1
heartbeat_port = 1050
keepalive = 6
deadtime = 18

rsh_command = ssh

network = nat
nat_router = 192.168.15.254 eth0:1

virtual server_119_129_http {
         address = 10.0.119.129 eth1:129
         active = 1
         load_monitor = uptime
         timeout = 5
         reentry = 10
         port = 80
         send = "GET / HTTP/1.0\r\n\r\n"
         expect = "HTTP"
         scheduler = wlc
         persistent = 60
         pmask = 255.255.255.255
         fwmark = 80
         protocol = tcp

         server app-1 {
                 address = 192.168.5.1
                 active = 1
                 weight = 1
         }

         server app-2 {
                 address = 192.168.5.2
                 active = 1
                 weight = 1
         }

         server app-3 {
                 address = 192.168.5.3
                 active = 1
                 weight = 1
         }
}

Best regards,

-- 
Sébastien BONNET     --    Ingénieur système
Tel: 04.42.25.15.40      GSM: 06.64.44.58.98