Re: Piranha server crash

Hi,

I've been using piranha for almost 2 years but I don't start the piranha daemon once the initial 
config has been done. I just manually configured the lvs.cf and use pulse daemon to apply config to 
ipvsadm and nanny to operate.

Piranha daemon is not really necessary to running if you know how LVS works and administrate through 
ipvsadm. You can shutdown piranha and give a try to check whether your lvs server resources are stable.

Hope this is helpful.

Regards
Hirantha

R R wrote:
> Hi Folks,
> 
> I setup a LVS server using piranha. After a week the server became 
> completely unresponsive , I couldn't even ping the server IP address.
> 
> After I started to using piranha, my graphics showed high usage of the 
> RAM (the server has 1G) ; however there were no other error/warning 
> messages found on file logs.
> 
> I'm using RHEL 4.3, 64bits ( kernel 2.6.9-34.EL), ipvsadm-1.24-6, 
> piranha-0.8.3.1-3.; lvs-rrd for graphics.
> 
> The amount of virtual servers are 24 (12 HTTP - 12 HTTPS) with 2 real 
> servers each.
> 
> Has anyone experienced similar issues?
> 
> Please advise.
> 
> PS: does anyone know of any other tool to get graphics for LVS connections.
> 
> 
> Thanks
> 
> ==
> 
> Bigo
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> Piranha-list mailing list
> [email protected]
> https://www.redhat.com/mailman/listinfo/piranha-list