RE: Network problems

Thanks again.  Refer to my other email.  I got the old ethernet port to
work.

I may try installing the 100mbs US Robotics card again with Tulip at
network kernel in linuxconf.

Vaughn

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Ajai Khattri
Sent: Monday, February 24, 2003 3:41 PM
To: [email protected]
Subject: Re: Network problems


On Mon, Feb 24, 2003 at 12:52:11PM -0800, Vaughn Warriner wrote:

> Dmesg | more does not include a line referring to eth0
> 
> etc/modules.conf shows
> alias eth0 3c523
> But I put that in when I was messing around with linuxconfig.  There 
> is no alias available for US Robotics that I could find.

I just heard back from USR - they say the USR997900 uses a Tulip
chipset. So you should be able to use:

alias eth0 tulip

in /etc/modules.conf

-- 
.jA
repoleveD \ .nimdA smetsyS



_______________________________________________
Guinness-list mailing list
[email protected]
https://listman.redhat.com/mailman/listinfo/guinness-list