Re: 2.6 Kernel and IDE dierect for burners

Audioslave - 7M3 - Live wrote:

>
> Thanks for the link, I was there and didn't know about the 
> module-init-tools. With the extreme aid of mc, I downloaded and 
> extracted the zipped file, ran ./configure, then make, followed by 
> make install. Then I checked for the presense of modprobe.conf.

Excellent work so far, now here is a key point -

 From the source directory of module-init-tools,
you need to run the following command:

./generate-modprobe.conf /etc/modprobe.conf

and it should all be good.

Also modprobe.conf should ideally be located in
/etc - I'm curious about the modprobe.conf file
you found - what are it's contents?

Best Regards,

Joe




-- 
Phoebe-list mailing list
[email protected]
https://listman.redhat.com/mailman/listinfo/phoebe-list