RE: XF86Config file question - starting XWindows in level 3
"Stephen Liu" <[email protected]>
| Newsgroups | gmane.linux.redhat.release.psyche |
|---|---|
| Message-ID | <[email protected]> |
Hi Michael, Thanks for your advice. Booting into Init 3 and login as root "startx" starts GUI as root "Ctrl + Alt + F2" returns back to Init 3 "Init 5" starts GUI but requesting for login again. B.Regards Stephen On Wed, 2003-08-27 at 23:28, [email protected] wrote: > >Message: 7 > >Subject: RE: XF86Config file question - Nvidia Driver > >From: "Stephen Liu" <[email protected]> > >To: <[email protected]> > >Date: 27 Aug 2003 17:48:16 +0800 > >Reply-To: [email protected] > > > >Hi Michael, > > > >Thanks for your advice. It works without problem. > > > >>From "Init 3" how to start xwindow > > > ># xwindow > ># service xwindow start > ># xwindow start > >Ctrl + Alt + F7 > >etc. > > > >could not work. > > > >Thanks in advance. > > > >B.Regards > >Stephen > > Hi Stephen, > > Simply type "startx" to use gui in level 3. When you type "init 5" you start the gui, but you also switch to level 5 which is a different level that level 3. The different levels can be set up run different configurations such as programs that you want to start up i.e. different "services" at boot time. > > Just remember "I want to start x so I startx" > > > Sincerely, > > Michael von Lehe To Get Your Own iCareHK.com Email Address? Go To www.iCareHK.com. -- Psyche-list mailing list [email protected] https://www.redhat.com/mailman/listinfo/psyche-list