Re: can't start ethernet
Ian Firla <[email protected]>
| Newsgroups | gmane.linux.redhat.release.seawolf |
|---|---|
| Message-ID | <[email protected]> |
irlan0 is, i think, your infrared port. Did you enable it in your kernel? Did work previously? Perhaps you can recompile without it? Ian ------------ Dr Ian Firla Robert Graves Trust | "A partial count of the software available St John's College, Oxford | in just one noncommerical Linux system OX1 3JP - +44-(0)7855-310565 | would have cost about $1.9 billion to develop http://www.robertgraves.org | ... the way Microsoft does it" Bruce Perens On Fri, 17 Jan 2003, Shane C Branch wrote: > I'm having some trouble starting my ethernet card with DHCHP. We recently > migrated from token ring to ethernet, so I recompiled the kernel and removed the > tr0 support. I shutdown, removed the tr card and installed the eth card. > However, the error I get at start up is 'delaying irlan0. I would have expected > it to report eth0. > > Where do I go to see if the system is detecting the card, and what do I need to > do to make it active? I messed with netcfg and linuxconfig, but had no luck with > either. > > regards, > > shane. > > > > _______________________________________________ > Seawolf-list mailing list > [email protected] > https://listman.redhat.com/mailman/listinfo/seawolf-list >