Re: Network setup for Dell 2950

Andrew Bacchi <[email protected]> Wed, 14 Mar 2007 11:32:29 -0400

Newsgroups	gmane.linux.redhat.release.taroon.general
Message-ID	<[email protected]>

I've seen that before.  Something like if you have one onboard NIC and 
an addon NIC the addon becomes eth0 and onboard is eth1.  If I'm 
remembering correctly. Counterintuitive.  It drove me nuts for awhile.

Mohammed Rahman wrote:
> Hi Folks,
> 
> Just to let you guys know that if you happen to configure Dell PowerEdge
> 2950 and setup your network on eth0 then you need to plug the network
> cable into "slot 2" and vice-versa.
> 
> But Dell 2650 or 2850 were not like that.
> 
> Thanks,
> Mohammed Rahman
> 
> --
> Taroon-list mailing list
> [email protected]
> https://www.redhat.com/mailman/listinfo/taroon-list
> 

-- 
veritatas simplex oratio est
		-Seneca

Andrew Bacchi
Systems Programmer
Rensselaer Polytechnic Institute
phone: 518.276.6415  fax: 518.276.2809

http://www.rpi.edu/~bacchi/

--
Taroon-list mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/taroon-list