Re: Copying an rhel as 3 installation from a PowerEdge 2650 to a 2950

Gene,
Is this not because you are specifying an e2label label for a device and you
haven't labelled it yet?

Try editing the grub line to say:  root=/dev/sda2 or wherever your root
partition is set.
When it has booted up (perhaps you do need to go down the rescue cd root or
single user mode (S) as this will aslo be specified in the /etc/fstab)

Kev

On 11/04/07, Tom Sightler <ttsig-mn7Ydl480yfqlBn2x/[email protected]> wrote:
>
>
> >
> >   These systems use different RAID controllers for the boot disk.
> > Because of this I have to load a new driver/module (megaraid_sas).
> > But, it is not working.  When I try to boot I get:
> >
> > VFS: Cannot open root device "LABEL=/" or 00:00
> > Please append a correct "root=" boot option
> > Kernel panic: VFS: Uname to mount root fs on 00:00
> >
>
>
-- 
Kevin Jackson RHCE

--
Taroon-list mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/taroon-list