Re: Cannot create an LVM disk layout on top of SW RAID in kickstart

On 5 Jun 2007, at 21:19, Paul Krizak wrote:
> At this point I'd actually be fine doing all the partitioning in % 
> pre and then just instructing anaconda to use the partitions I  
> create, but I don't know what LVM/partitioning commands are  
> available in BusyBox inside anaconda.

The easiest way to find out is to boot something into the install and  
hit Alt-F2 or go via rescue mode and just try out LVM. We tend to do  
that on each new release to see if our custom %pre scripts still work.

--
Sam

--
Taroon-list mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/taroon-list