Re: Problem with RAID
"Rajan Mithani" <[email protected]>
| Newsgroups | gmane.linux.redhat.rhn.user |
|---|---|
| Message-ID | <[email protected]> |
Hi Bruno here are the few commands for RAID Hope this would be useful to you... cat /proc/mdstat ( Showing the RAID STATISTACS ) mdadm is the command for RAID if you wann to add any drive 1st your are supposed to create a physical volume thru mdadm--create command go for syntax thru MAN PAGES Regards Rajan Mithani SysAdmin @ IBM RHCE On Fri, May 2, 2008 at 9:12 AM, Bruno de Oliveira Bastos < [email protected]> wrote: > Hi, i have a IBM 226 with 2 HDs with Hardware RAID in RAID 1, and the > Linux partition is monted in /dev/mapper/asr_LINUXp1 ( where is the / ) and > /dev/mapper/asr_LINUXp2 ( where is the swap ). Now i put more 2 HDs in > Hardware RAID and RAID 1 for my application, but how i can create, or edit > the partition of RAID ? I have to use /dev/mapper/asr_LINUXp3 ? How i can do > this ? The disk druid create the firs /dev/mapper/asr_LINUX, but how i can > this again ? > _______________________________________________ > rhn-users mailing list > [email protected] > https://www.redhat.com/mailman/listinfo/rhn-users > _______________________________________________ rhn-users mailing list [email protected] https://www.redhat.com/mailman/listinfo/rhn-users