Re: San and devices

It's hitachi open v

thanks
paras

On Thursday, January 7, 2010, Lamon, Frank III <[email protected]> wrote:
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> If it’s an EMC array you may want to
> check that the SPC-2 bit is enabled. Also, depending on how the array is set up
> you may see 4 devices for each physical LUN (redundant FAs on the array will
> present 2 devices on each of your HBA paths).
>
>
>
> Frank LaMon
>
>
>
>
>
>
>
>
>
>
>
> From:
> [email protected] [mailto:[email protected]] On Behalf Of Paras pradhan
> Sent: Thursday, January 07, 2010
> 11:39 PM
> To: [email protected]
> Subject: [rhn-users] San and
> devices
>
>
>
>
>
> My 5.4 box has a single HBA card with 2 ports connected to my Storage.
> 2 Luns are assigned to my HBA card. Under /dev instead of seeing 4 devices I
> can see 12 devices from sdb to sdm. I am using qlogic driver that is bulitin to
> the OS. Has any one seen this kind of situation?
>
>
> Paras.
>
>
>
>
>
>
>
>
>
> This email transmission and any accompanying attachments may contain CSX privileged and confidential information intended only for the use of the intended addressee.  Any dissemination, distribution, copying or action taken in reliance on the contents of this email by anyone other than the intended recipient is strictly prohibited.  If you have received this email in error please immediately delete it and  notify sender at the above CSX email address.  Sender and CSX accept no liability for any damage caused directly or indirectly by receipt of this email.
>