Re: mythtv .27 centos 7 rpm feedback

On 25/02/2015 3:19 PM, Barry Quiel wrote:
>
>
> On 2/24/2015 1:20 AM, Duncan Brown wrote:
>> On 24/02/2015 06:38, Stephen Collier wrote:
>>> On 24/02/2015 4:08 pm, Barry Quiel wrote:
>>>> Stephen -
>>>>
>>>> Thanks for the CentOS7 packages of .27.  I have been looking for them
>>>> for a while.  A quick piece of feedback.  It looks like python-Mythtv
>>>> is missing a dependency.  None of the metadata lookups would work
>>>> until I added python-lxml.  It didn't get added as a dependency. This
>>>> could be my issue however.  I used the CentOS minimal install disk
>>>> and added from there.  It's possible that python-lxml would get
>>>> installed from a "normal install"
>>>>
>>>> Also one request:  Any chance your next build of mythtv you could
>>>> include hdmi-cec support?  I installed libcec from your repo and can
>>>> see the cec traffic with my pulse8 adapter.  The key presses just
>>>> aren't getting into mythfrontend.  I did a mythfrontend --version and
>>>> didn't see cec listed.  My guess is that you didn't compile in cec
>>>> support in myth, but I could be doing it wrong too.
>>>>
>>>> _______________________________________________
>>>> atrpms-users mailing list
>>>> [email protected]
>>>> http://lists.atrpms.net/mailman/listinfo/atrpms-users
>>>>
>>> Barry,
>>>
>>> Thanks for the info. I'll add it to the build. I've tried a couple of
>>> times to get cec in the build (not too hard) but it ignores it at
>>> configure time. If I know someone wants it I'll have a much harder
>>> look as I wanted to include it in the original builds.
>>>
>>> Cheers
>>> Stephen
>>>
>>> _______________________________________________
>>> atrpms-users mailing list
>>> [email protected]
>>> http://lists.atrpms.net/mailman/listinfo/atrpms-users
>> I think it needs this patch to work with the version of libcec I assume
>> you are using
>>
>> https://code.mythtv.org/trac/ticket/11338
>>
>> _______________________________________________
>> atrpms-users mailing list
>> [email protected]
>> http://lists.atrpms.net/mailman/listinfo/atrpms-users
>
> So no luck on the new packages.  I'm not sure if its actually getting 
> compiled in.  I recall you mentioning you were have problems and it 
> was being ignored by configure.  When I do a mythfrontend --version I 
> would expect to see something like using_cec or using_libcec.  I don't 
> see that, but I could be wrong.  I also don't see mythfrontend linked 
> against libcec.  But it's possible that they aren't linking against 
> the library and just reading raw from the /dev/tty.  In that case all 
> my assumptions would be incorrect.
>
> _______________________________________________
> atrpms-users mailing list
> [email protected]
> http://lists.atrpms.net/mailman/listinfo/atrpms-users
>
Barry,

Sorry the new packages built before I made the changes. Automatic builds 
help me not have to keep kicking them off but they sometimes build at 
the wrong time. The 27.4-20 rpms are the ones you need. They should 
build over the next couple of hours. Mock which is part of the build 
system broke so I had to patch it before anything would build hence the 
delay.

Let me know if it works. It should be there soon.

Cheers
Stephen