Re: Making a slight modification and replacing an rpm with the same version - is it possible ?

Hi,

Thanks.
What is the easiest way (and most correct) to
bump the release number ? is it just rename the new rpm I created to
something a bit higher, like  net-tools-1.60-88.fc9.x86_64.rpm
(instead of net-tools-1.60-87.fc9.x86_64.rpm)?
Or are there any more things I should do (change spec file, etc) in order to
"bump the release number" ?

Regards,
IB

On Wed, May 21, 2008 at 3:56 PM, Matthew Miller <[email protected]> wrote:
> On Wed, May 21, 2008 at 03:39:04PM +0300, Ian Brown wrote:
>> I had downloaded net-tools src rpm and I made a very minor change in the source
>> code.
>> Now I created a new rpm after applying this change to the newly created rpm.
>> (using adding the modification to the .bz2, using rpmbuild, etc).
>> The new rpm I created is net-tools-1.60-87.fc9.x86_64.rpm.
>> I have also the same version (net-tools-1.60-87.fc9.x86_64.rpm) installed on my
>> machine.
>> Is there a way I can replace the new rpm instead the old one?
>
> You can force this to work with -Uvh --oldpackage. But really, what you want
> to do is bump the release number. This will both make an upgrade work
> seamlessly _and_ at the same time document that it's not the unmodified RPM.
>
>
> --
> Matthew Miller           [email protected]          <http://mattdm.org/>
> Boston University Linux      ------>              <http://linux.bu.edu/>
>
> _______________________________________________
> Rpm-list mailing list
> [email protected]
> https://www.redhat.com/mailman/listinfo/rpm-list
>