RE: Setting up th0

Then you need to download the OCO LCS module from DeveloperWorks and follow
the instructions to copy them into the initrd used for installation.

Mark Post

-----Original Message-----
From: Simon Tischer [mailto:[email protected]]
Sent: Tuesday, March 26, 2002 4:03 AM
To: Rob van der Heij
Cc: [email protected]
Subject: Re: [Redhat-s390-list] Setting up th0


hi
i tested it and get following error

error: no lcs module fount
SIOCSIFADDR: No such device
tr0: unknown interface: No such device.

Mit freundlichen Grüßen

                                         Simon Tischer




IBM Deutschland GmbH
PL Ausbildung Stuttgart 1
KST:3167, Loc 70569-01
Pascalstraße 100, D-70548 Stuttgart
Phone: +49 07031 - 16 4519 (Praxiseinsatz) *120-4519:int.
Phone: +49 0711-785 5443 (Sekretriat ,ext.) *111-5443;int.
E-Mail: [email protected]



Montag, 25. März 2002 19:12
To: Simon Tischer/Germany/IBM@IBMDE, [email protected]
cc:
From: Rob van der Heij <[email protected]>
Subject: Re: [Redhat-s390-list] Setting up th0




>
>Please enter the network device you inted to use (e.g ctc0, escon0, iucv0,
>eth0, tr0)
>[here i typed tr0]
>
>Please enter any parameters you need to pass to the channel decive layer.
>(e.g. "ctc0,0x600,0x601" will activate the ctc interface at I/O ports
>0x600,0x6001):
>[And here i dont know what to typ]


lcs0,0x600,0x601,0,nr

This is assuming your lcs device is at address 600/601 and for 'nr' you
need the port number of the LCS device (depends on your hardward whether
that is needed). Look in the Device Driver PDF on Developer Works.

Rob


_______________________________________________
Redhat-s390-list mailing list
[email protected]
https://listman.redhat.com/mailman/listinfo/redhat-s390-list


_______________________________________________
Redhat-s390-list mailing list
[email protected]
https://listman.redhat.com/mailman/listinfo/redhat-s390-list