Tecra 8000 sound w/RedHat 8.0

Hello group,

Just for the record, I was able to configure the sound on my Toshiba Tecra 
8000 by following some old directions left online for RedHat 7.1.  I'm only 
posting it because when I was trying to find this information, it wasn't 
posted in an obvious form elsewhere.  I tried other posted techniques, but 
only this one worked for me.

Here's the re-print:

run /usr/sbin/sndconfig as root

Choose "Sound Blaster Pro" from the list. Make sure I/O = port 0x220, IRQ = 
5, DMA = 0. (If that doesn't work you could try looking in the BIOS to see 
what it thinks the values should be -- press ESC (followed by F1 when 
prompted at boot).

Make sure the entry in /etc/modules.conf looks something like:

alias sound-slot-0 sb

post-install sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -L >/dev/null 
2>&1 || :

pre-remove sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -S >/dev/null 
2>&1 || :

options sound dmabuf=1
alias synth0 opl3
options opl3 io=0x388
options sb io=0x220 irq=5 dma=0

[back to me speaking...]

Also note that sndconfig isn't installed on Redhat 8.0 by default.  To 
install it, you'll need Redhat install disk 3.  On that disk, run the RPM at 
/mnt/cdrom/RedHat/RPMS/sndconfig-0.69-1.i386.prm.  sndconfig will be 
installed in /sbin

Cheers!

_________________________________________________________________
MSN 8 helps eliminate e-mail viruses. Get 2 months FREE*.  
http://join.msn.com/?page=features/virus