Re: Re: Sound problem with RedHat 8.0

Hi Bill,

Thanks for the answer.

I should have been more precise in my previous post: I'm using es1371 
driver. I tried only once the sb one to check if this can solve my 
problem. Sorry for the consfusion. All the data supplied with the post 
is with the es1371 driver. dmseg shows a lot of the following error message:

    Device not ready.  Make sure there is a disc in the drive.

I'm still having the same issue described in the posted e-mail.

Thanks again,

Djudrjura.

------------------------------------------------------------------------

PS. If it can be of any help, here is the output of lspci command:

    # /sbin/lspci -vnn
    00:00.0 Class 0600: 8086:1a30 (rev 04)
            Subsystem: 1043:8070
            Flags: bus master, fast devsel, latency 0
            Memory at f8000000 (32-bit, prefetchable) [size=64M]
            Capabilities: [e4] #09 [9104]
            Capabilities: [a0] AGP version 2.0

    00:01.0 Class 0604: 8086:1a31 (rev 04)
            Flags: bus master, 66Mhz, fast devsel, latency 64
            Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
            I/O behind bridge: 0000d000-0000dfff
            Memory behind bridge: ef000000-efdfffff
            Prefetchable memory behind bridge: eff00000-f7ffffff

    00:1e.0 Class 0604: 8086:244e (rev 05)
            Flags: bus master, fast devsel, latency 0
            Bus: primary=00, secondary=02, subordinate=02, sec-latency=32
            I/O behind bridge: 0000b000-0000bfff
            Memory behind bridge: ee800000-eeffffff
            Prefetchable memory behind bridge: efe00000-efefffff

    00:1f.0 Class 0601: 8086:2440 (rev 05)
            Flags: bus master, medium devsel, latency 0

    00:1f.1 Class 0101: 8086:244b (rev 05) (prog-if 80 [Master])
            Subsystem: 1043:8028
            Flags: bus master, medium devsel, latency 0
            [virtual] I/O ports at 01f0
            [virtual] I/O ports at 03f4
            [virtual] I/O ports at 0170
            [virtual] I/O ports at 0374
            I/O ports at a800 [size=16]

    00:1f.2 Class 0c03: 8086:2442 (rev 05)
            Subsystem: 1043:8028
            Flags: bus master, medium devsel, latency 0, IRQ 5
            I/O ports at a400 [size=32]

    00:1f.4 Class 0c03: 8086:2444 (rev 05)
            Subsystem: 1043:8028
            Flags: bus master, medium devsel, latency 0, IRQ 9
            I/O ports at a000 [size=32]

    01:00.0 Class 0300: 1002:5144
            Subsystem: 1002:0008
            Flags: bus master, stepping, 66Mhz, medium devsel, latency
    64, IRQ 11
            Memory at f0000000 (32-bit, prefetchable) [size=128M]
            I/O ports at d800 [size=256]
            Memory at ef000000 (32-bit, non-prefetchable) [size=512K]
            Expansion ROM at effe0000 [disabled] [size=128K]
            Capabilities: [58] AGP version 2.0
            Capabilities: [50] Power Management version 2

    02:0b.0 Class 0401: 1274:5880 (rev 02)
            Subsystem: 1274:2000
            Flags: bus master, slow devsel, latency 32, IRQ 9
            I/O ports at b800 [size=64]
            Capabilities: [dc] Power Management version 1

    02:0e.0 Class 0200: 10b7:9055 (rev 30)
            Subsystem: 10b7:9055
            Flags: bus master, medium devsel, latency 32, IRQ 10
            I/O ports at b400 [size=128]
            Memory at ee800000 (32-bit, non-prefetchable) [size=128]
            Expansion ROM at <unassigned> [disabled] [size=128K]
            Capabilities: [dc] Power Management version 1



[email protected] wrote:

>Djurdjura H. ([email protected]) said: 
>  
>
>>In summary: I have no sound under RedHat 8.0.
>>
>>I have a Soundblaster 16 PCI installed (actually, I thought that the 
>>previous sound card I had was too cheap and this was why it did not work 
>>under RedHat8.0, so I bought this one 2 days ago, with no more luck).
>>
>>This card works just fine under WinXP. But under RedHat8.0 no sound at 
>>all. I usually use Gnome as my window manager.
>>
>>When I run sndconfig, I first get the following auto-detected sound card:
>>    Ensoniq 5880 AudioPCI es1371
>>
>>When I try to manually use the Sounblaster 16 driver under sndconfig, I 
>>get the following problem (frankly, I don't understand most of the 
>>fields to fill in!):
>>
>>modprobe errror
>>
>>The following error occurred running the modprobe program:
>>/lib/modules/2.4.18-27.8.0/kernel/drivers/sound/sb.o: init_module: No 
>>such device
>>/lib/modules/2.4.18-27.8.0/kernel/drivers/sound/sb.o: insmod
>>/lib/modules/2.4.18-27.8.0/kernel/drivers/sound/sb.o failed
>>/lib/modules/2.4.18-27.8.0/kernel/drivers/sound/sb.o: insmod
>>sound-slot-0 failed
>>
>>Thanks in advance for any help,
>>    
>>
>
>Don't use the 'sb' driver, use the 'es1371' driver.
>
>Bill
>
>
>
>_______________________________________________
>Sound-list mailing list
>[email protected]
>https://listman.redhat.com/mailman/listinfo/sound-list
>  
>