how to set lilo.conf to display boot messages with redhat 7.3
"munhyo Jung" <[email protected]> Thu, 25 Sep 2003 21:44:42 +0900
| Newsgroups | gmane.linux.redhat.general,gmane.linux.redhat.stronghold |
|---|---|
| Message-ID | <[email protected]> |
hello,
I'm munhyo.
Let me ask you questions about LILO parameter.
I am used to use serial output to display boot messages with 2.4.18 kernel
as follows,
append="console=/dev/ttyS0,115200" in lilo.conf file.
But redhat 7.3 with 2.4.18-3 does not work as serial output to display boot
messages
with lilo parameters, append="console=/dev/ttyS0,115200".
Q1. How can I set lilo to use serial output to display boot messages with
redhat 7.3?
Q2. Can you explain how append parameter of lilo.conf pass to linux kernel?
Best regards,
munhyo
_________________________________________________________________
Help STOP SPAM with the new MSN 8 and get 2 months FREE*
http://join.msn.com/?page=features/junkmail
--
redhat-list mailing list
unsubscribe mailto:[email protected]?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list