RE: zipl does not pick up "new" disks

I don't think the change to modules.conf was necessary.  What did you put in
there?

Did you re-IPL after re-running zipl?  If so, what does Linux report for the
parmfile during the boot process (very near the beginning of the messages
coming out).


Mark Post

-----Original Message-----
From: Bradley Schmidt [mailto:[email protected]]
Sent: Wednesday, October 15, 2003 10:41 AM
To: [email protected]
Subject: zipl does not pick up "new" disks


We installed beta2 with disks 8000-8003, 8fff.  We're trying to change to
8000-8007

We've updated /etc/zipl.conf and /etc/modules.conf with the new devices.  We
ran zipl.  The /boot/parmfile.1 now correctly indicates dasd=8000-8007.

We note that the previous /boot/parmfile.1 did NOT have the
dasd=8000-8003,8fff parameter, but the /etc/modules.conf DID have the
parameter.  However, even after setting the files and running zipl, we are
still getting 8000-8003,8fff.

What else do we need to change?  Where is this information stored?


--
Taroon-beta-list mailing list
[email protected]
http://www.redhat.com/mailman/listinfo/taroon-beta-list


--
Taroon-beta-list mailing list
[email protected]
http://www.redhat.com/mailman/listinfo/taroon-beta-list