Re: XFree86-4.0.3-6 & 2nd Monitor

> It is called "clone mode", which intentionally displays the same 
> image on both displays.

Hm, with "CloneMode" "off" I got mirrowing again ....


Another thing I detected that I cannot understand:

An extract from XFree86.0.log:

[...]
(II) Bus -1: bridge is at (0:2:0), (0,-1,-1), BCTRL: 0x0008 (VGA_EN is
set)
(--) PCI:*(1:0:0) ATI Technologies Inc Radeon R250 If [Radeon 9000] rev
1, Mem @ 0xc0000000/27, 0xcfef0000/16, I/O @ 0xb800/8, BIOS @
0xcfec0000/17
(--) PCI: (1:0:1) ATI Technologies Inc Radeon R250 [Radeon 9000]
(Secondary) rev 1, Mem @ 0xb8000000/27, 0xcfee0000/16
[...]

I quess, PCI1:0:0 and 1:0:1 are detected.... but then, this appears some
lines later:

(II) Primary Device is: PCI 01:00:0
(WW) RADEON: No matching Device section for instance (BusID PCI:1:0:1)
found

Why was 1:0:1 first detected and later no device section was found???
See my XF86Config's device sections here:

Section "Device"
	Identifier  "Videocard0"
	Driver      "radeon"
	VendorName  "Videocard vendor"
	BoardName   "ATI Radeon 9000"
	VideoRam    131072
	BusID       "PCI:1:0:0"
EndSection

Section "Device"
	Identifier  "Videocard1"
	Driver      "radeon"
	VendorName  "Videocard vendor"
	BoardName   "ATI Radeon 9000"
	VideoRam    131072
	BusID       "PCI:1:0:1"
	Screen      1
EndSection


What does that mean???

-Marco



_______________________________________________
xfree86-list mailing list
[email protected]
https://listman.redhat.com/mailman/listinfo/xfree86-list
IRC: #xfree86 on irc.redhat.com