Re: Will someone share their XF86Config-4 for RH9?
Mike Chambers <[email protected]>
| Newsgroups | gmane.linux.redhat.xfree86 |
|---|---|
| Message-ID | <[email protected]> |
On Thu, 2003-05-08 at 07:01, Øystein Gisnås wrote: > I installed RH9 w/o XFree86 initially, but now I needed to install the packages. Problem is that XF86Config-4 is usually generated by anaconda. So install the packages and you *should* get a config file. Even if you don't, start up xfs, and just run redhat-config-xfree86 to get your system setup. Not sure I see what your asking here. -- Mike Chambers Madisonville, KY "Hand over the code, and no one gets hurt!" _______________________________________________ xfree86-list mailing list [email protected] https://listman.redhat.com/mailman/listinfo/xfree86-list IRC: #xfree86 on irc.redhat.com