HP All-in-one scanner problem

I recently purchased a new HP All-in-one machine model 3835. I
checked on http://hplipopensource.com/ and the model is listed as
having full Linux support. I am running Debian 8.1. I am able to
print. However, when I run scanimage -L it does not find the scanner
at all. I tried adding the IP address of the device to the net.conf
file in /etc/sane.d and when I run scanimage -L with debug messages
I get the following:

SANE_DEBUG_NET=255 scanimage -L

[sanei_debug] Setting debug level of net to 255.

[net] sane_init: authorize != null, version_code != null

[net] sane_init: SANE net backend version 1.0.14 (AF-indep+IPv6)
from sane-backends 1.0.24

[net] sane_init: Client has little endian byte order

[net] sane_init: searching for config file

[net] sane_init: trying to add 10.0.0.24

[net] add_device: adding backend 10.0.0.24

[net] net_avahi_browse_callback: CACHE_EXHAUSTED

[net] add_device: backend 10.0.0.24 added

[net] sane_init: done reading config

[net] sane_init: evaluating environment variable SANE_NET_HOSTS

[net] sane_init: evaluating environment variable SANE_NET_TIMEOUT

[net] sane_init: done

[net] sane_get_devices: local_only = 0

[net] connect_dev: trying to connect to 10.0.0.24

[net] connect_dev: [0] failed to connect (Connection refused)

[net] connect_dev: couldn't connect to host (see messages above)

[net] sane_get_devices: ignoring failure to connect to 10.0.0.24

[net] sane_get_devices: finished (0 devices)

[net] net_avahi_browse_callback: ALL_FOR_NOW

I tried to search for solutions but haven't found anything. Anyone
have any solutions or suggestions of where to look?

Thanks,

--
David Suna
david-lbDOmM3XA9gS/[email protected]

_______________________________________________
Linux-il mailing list
[email protected]
http://mailman.cs.huji.ac.il/mailman/listinfo/linux-il