Re: KODI on Raspberry PI2 - no screen output
Shlomo Solomon <[email protected]>
| Newsgroups | gmane.linux.region.israel |
|---|---|
| Message-ID | <[email protected]> |
On Tue, 20 Oct 2015 19:29:18 +0300 Efraim Flashner <efraim-13Rj+LLFh/9S1MOuV/[email protected]> wrote: > On Tue, 20 Oct 2015 19:16:13 +0300 > Shlomo Solomon <[email protected]> wrote: > > > I installed Raspbian, OSMC and OpenELEC on a new Raspberry PI2 from > > the latest version of NOOBS (Jessie). > > > > Raspbian works fine. > > > > Both OSMC and OpenELEC run KODI immediately after booting. But in > > both cases, after seeing a Logo for a few seconds, there's no > > output to the screen. In both cases, the PI is still "alive" - I > > can ping it - just no output to the screen. > > > > I tried installing KODI on the working Raspbian (apt-get install > > kodi). After a successful installation, I ran KODI - both from the > > Raspbian menu and from the CLI. In both cases, I again get no > > output to the screen. > > > > Any ideas? > > > > How much time did you give it to load? Recently I've noticed that > launching KODI triggers an apt-cache process to check for something. > It takes a couple of seconds on my older netbook, but on a RPi2 I > could imagine it would take a bit longer > I waited several minutes - thought it might be a delay caused on the first run. But friends have told me that KODI boots in seconds on a PI2. -- Shlomo Solomon http://the-solomons.net Sent by Claws Mail 3.11.1 - KDE 4.12.15 - LINUX Mageia 4 _______________________________________________ Linux-il mailing list [email protected] http://mailman.cs.huji.ac.il/mailman/listinfo/linux-il