Re: Arduino on Mageia linux

Hi , 

I had a similar issue when I checked the wrong board in the IDE (few years ago 
things may have changed). 

Unplug the device , close the IDE , plug it in again and : 

dmesg
ls /dev/serial/by-*

start the IDE again and make sure you choose the correct board. 

On Tuesday, 20 June 2017 13:32:28 IDT Shlomo Solomon wrote:
> I installed the Arduino IDE from Mageia RPMs and added my user to the
> lock group as instructed.
> 
> In the tools >> serial port menu, there is no  /dev/ttyUSB0 -
> only /dev/ttyS0 and  /dev/ttyS1. I tried both of them but could not
> upload a program. I read that sometimes Arduino needs to be run as
> root, so I tried that too with no success. Here's what I get when I try
> to upload:
> 
> Binary sketch size: 1,056 bytes (of a 32,256 byte maximum)
> Binary sketch size: 1,056 bytes (of a 32,256 byte maximum)
> avrdude: stk500_recv(): programmer is not responding
> avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
> avrdude: stk500_recv(): programmer is not responding
> avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
> avrdude: stk500_recv(): programmer is not responding



_______________________________________________
Linux-il mailing list
[email protected]
http://mailman.cs.huji.ac.il/mailman/listinfo/linux-il