Re: auth learn

Jens Kasten <[email protected]>
Newsgroups gmane.linux.rsbac
Message-ID <1213371613.6969.1.camel@jaschtschik-pc>
thx for the tip,
# CONFIG_RSBAC_AUTH_LEARN is not set
usally i am enable this, but somehow i had forgot it.
jens

Am Freitag, den 13.06.2008, 16:48 +0200 schrieb Javier Martínez:
> Please send your .config configuration related with rsbac and send the
> output of one attr_get_file_dir AUTH FD "/route_to/sshd" auth_learn
> 
> 2008/6/12 Jens Kasten <[email protected]>:
> > Hi
> > no i try this but nothing.
> >
> > Am Donnerstag, den 12.06.2008, 20:25 +0200 schrieb Javier Martínez:
> >> Maybe you need to specify the AUTH module, try this:
> >>
> >> attr_set_file_dir AUTH FILE "/usr/sbin/sshd" auth_learn 1
> >>
> >> 2008/5/1 Jens Kasten <[email protected]>:
> >> > Hi list,
> >> > on the Version: 1.4.0-pre3
> >> > the auth learn does not work
> >> > i set this
> >> >        attr_set_file_dir FILE "/usr/sbin/sshd" auth_learn 1
> >> >
> >> > and on the Version: 1.3.7
> >> > the rsbac UM doesnt not work correct.
> >> > i have on /etc/nsswitch.conf
> >> > passwd:     rsbac
> >> > shadow:     rsbac
> >> > group:      rsbac
> >> >
> >> > and on the /etc/pam.d/system-auth
> >> > #auth      required     pam_rsbac.so
> >> > #account    required     pam_rsbac.so
> >> > #password   required     pam_rsbac.so
> >> > #session    required     pam_rsbac.so
> >> >
> >> > auth       sufficient     pam_rsbac.so
> >> > account    sufficient     pam_rsbac.so
> >> > password   sufficient     pam_rsbac.so
> >> > session    sufficient     pam_rsbac.so
> >> >
> >> > if i use the required i get this
> >> > May  1 12:00:47 jaschtschik sshd[31738]: (pam_rsbac) error not handled:
> >> > No such file or directory
> >> > May  1 12:00:50 jaschtschik sshd[31738]: Failed password for jens from
> >> > 192.168.1.5 port 52671 ssh2
> >> >
> >> > with the suffucient i get
> >> > May  1 12:09:27 jaschtschik sshd[31767]: Accepted password for jens from
> >> > 192.168.1.5 port 58927 ssh2
> >> > May  1 12:09:27 jaschtschik sshd[31770]: (pam_rsbac) session opened for
> >> > user jens by *unknown*(uid=0)
> >> >
> >> > on the 1.4.0pre3 there the UM works well.
> >> >
> >> > grüsse
> >> > jens
> >> >
> >> >
> >> > _______________________________________________
> >> > rsbac mailing list
> >> > [email protected]
> >> > http://www.rsbac.org/mailman/listinfo/rsbac
> >> _______________________________________________
> >> rsbac mailing list
> >> [email protected]
> >> http://www.rsbac.org/mailman/listinfo/rsbac
> >
> > _______________________________________________
> > rsbac mailing list
> > [email protected]
> > http://www.rsbac.org/mailman/listinfo/rsbac
> _______________________________________________
> rsbac mailing list
> [email protected]
> http://www.rsbac.org/mailman/listinfo/rsbac

_______________________________________________
rsbac mailing list
[email protected]
http://www.rsbac.org/mailman/listinfo/rsbac
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.