Re: rsbac-admin

Hi,

If you're using git-master version rsbac-admin (1.5.0), then you need to
use git-master version kernel...
I suggest for you: replace to a stabil branch rsbac-admin.

Aleph

> -------- Original Message --------
> Subject: Re: [rsbac] rsbac-admin
> From: Jens Kasten <[email protected]>
> Date: Wed, February 02, 2011 10:35 am
> To: RSBAC Discussion and Announcements <[email protected]>
> 
> 
> Hmm, strange.
> I did as unprivileged user make build and as root user make install and
> got the error below.
> When i do as root user (make clean) only make install its just install
> it.
> 
> I use the latest git rsbac-admin and rsbac-kernel.
> rsbac_version 
> Tools: 1.5.0, Kernel: 1.4.5, Tools-String: 1.5.0
> 
> Through this i can't setup anything because: RSBAC_EINVALIDVERSION
> 
> 
> Am Mittwoch, den 02.02.2011, 09:48 +0100 schrieb Jens Kasten:
> > Hi list,
> > 
> > i get on git rsbac-admin after make build and than make install this:
> > Installing RSBAC NSS...
> >  -------------------------------------
> >   INTO		 (/usr/local)
> >   DIR		/usr/local/lib
> >   INSTALL	libnss_rsbac.la
> > libtool: install: warning: relinking `libnss_rsbac.la'
> > libtool: relink: `interface.lo' is not a valid libtool object
> > libtool: install: error: relink `libnss_rsbac.la' with the above command
> > before installing it
> > make[1]: *** [install] Fehler 1
> > make: *** [nss-install] Fehler 2
> > 
> > Jens 
> > 
> > _______________________________________________
> > rsbac mailing list
> > [email protected]
> > http://www.rsbac.org/mailman/listinfo/rsbac
> 
> 
> _______________________________________________
> rsbac mailing list
> [email protected]
> http://www.rsbac.org/mailman/listinfo/rsbac