Re: A problem when pulling linux-3.8.y

Hi,

on evening I will look on my setup. I think I have the FF module 
enabled too but is booting.


Am 2013-05-14 05:28, schrieb Mikko Rinne:
> Hi,
>
> Regarding this, I did some more digging. I disabled all the modules, 
> enabled
> one at a time rebooteed and see where the error occurs.
>
> It seems that FF policy module is doing the trick. When I have FF 
> enabled,
> system hangs on that error message. Basicly all I need FF for is 
> pretty much
> preventing people from executing nothing but allowed binaries, but I 
> think I
> can use ACL for that as well, have to do some digging.
>
> Either way I think FF should be fixed, at some point.
>
>
>
> -----Original Message-----
> From: Mikko Rinne [mailto:[email protected]]
> Sent: 14. toukokuuta 2013 5:16
> To: 'RSBAC Discussion and Announcements'
> Subject: RE: [rsbac] A problem when pulling linux-3.8.y
>
> Hey,
>
> Sorry for spamming this mailing list, but;
>
> I finally managed to clone linux-3.8.y (dont know if someone fixed it 
> or
> so), but I've came across a new problem which seems to persist in 
> 3.7.y as
> well, I tried to clone 3.7.y which currently runs in rsbac-3.7.10+ 
> version.
>
> - I have AUTH, ACL, FF and CAP modules enabled
> - Whenever I boot with softmode on, I got no problems
> - Regardless which options I try with these modules enabled, I always 
> get
> "rsbac boot cannot set terminal process group (-1) inappropriate 
> ioctl for
> device" -error on boot. And like I said, when I have rsbac_softmode 
> enabled
> in the command line, it boots with no problem, so it's not a problem 
> with
> the system, but within a kernel
> - I'm not using any initrd files
>
> My grub.conf goes pretty much like this:
>
> -- being copypaste --
> title Gentoo Linux 3.8.13+ rsbac (softmode) root (hd0,0) kernel
> /boot/vmlinuz-3.8.13-rsbac+ root=/dev/sda3 rsbac_cap_process_hiding
> rsbac_auth_enable_login rsbac_softmode rsbac_auth_learn vga=0x334
>
> title Gentoo Linux 3.8.13+ rsbac (hardmode) root (hd0,0) kernel
> /boot/vmlinuz-3.8.13-rsbac+ root=/dev/sda3 rsbac_cap_process_hiding
> vga=0x334
> -- end copypaste --
>
> I've attached a screenshot from vmware console so you guys can see it 
> as
> well.
>
> Any help would be appreciated.
>
> _______________________________________________
> rsbac mailing list
> [email protected]
> http://www.rsbac.org/mailman/listinfo/rsbac

-- 
Mit freundlichen Grüßen

Jens Kasten
_______________________________________________
rsbac mailing list
[email protected]
http://www.rsbac.org/mailman/listinfo/rsbac