Re: daz access mask error

Ok, but has root assigned the DAZ_ROLE flag to Administrator
(rsbac_user_menu)

2013/8/9 Jens Kasten <[email protected]>

> I set not in clamd.conf an user.
>
> On two other machines with similar setup its work.
>
> Am Freitag, den 09.08.2013, 12:08 +0200 schrieb Javier Juan Martínez
> Cabezón:
> > I'm not at home now to confirm, but I remember that to switch DAZ to
> > other user I had to switch the DAZ_ROLE to appropiated one, can you
> > send which value has user root in this to see if this is ok?
> >
> > 2013/8/9, Jens Kasten <[email protected]>:
> > > I set this daz_scanner, but this is left
> > >
> > >  ERROR: Clamuko: Can't set access mask in Dazuko
> > >
> > >> > Hi list,
> > >> >
> > >> > I try to get clamd with dazuko running but I get this error.
> > >> >
> > >> > Thu Aug  8 21:59:42 2013 : 60004465570|rsbac_adf_request(): request
> > >> > READ_WRITE_OPEN, pid 24195, ppid 23171, prog_name clamd, uid 0,
> remote
> > >> > ip 192.168.1.5, target_type DEV, tid char 250:00, attr open_flag,
> value
> > >> > 32770, result NOT_GRANTED (Softmode) by DAZ
> > >>
> > >> You need to mark clamd as daz_scanner, i.e., set that attribute value
> to
> > >> 1.
> > >>
> > >> Amon.
> > >
> > >
> > > _______________________________________________
> > > rsbac mailing list
> > > [email protected]
> > > http://www.rsbac.org/mailman/listinfo/rsbac
> > >
> > _______________________________________________
> > rsbac mailing list
> > [email protected]
> > http://www.rsbac.org/mailman/listinfo/rsbac
>
>
> _______________________________________________
> rsbac mailing list
> [email protected]
> http://www.rsbac.org/mailman/listinfo/rsbac
>